Various 1982-1993 GM S10/Sonoma Truck Parts. Need to clean up and sell some of the parts hoard I currently have. I do NOT have any frames, engines, 4x4 parts, rear diffs, interiors, or bumpers. What is listed below is what I currently have available to sell, Prices are OBO.
- 2.8 V6 Fiero Valve Covers. No gaskets or hardware. In good condition. $35
- 82-93 Front Bumper Impact bumperettes. I've never seen another set like them. $50
- Stock Taillights with trim ring. USED, Driver quality. $5
- 84 S10 Dash. Cluster and Heater controls condition unknown. Good parts dash. $50
- Bob Grant(GrantFab) Taillight filler panels for s10 or s10 blazer, New. $50
- 87+up Grey Glovebox door. $5
- 87+ up Grey Ashtray. $2
- Tan Foam Door Panel Arm Rests, 2 sets available. $5 a set.
- Glue In extended cab glass out of an 84 S10, will fit other ext. cab years. $35
- Yellow GMC tailgate, Good condition. $50
- Red GMC tailgate, Good condition. $50
- Pair of Manual window, manual lock doors with all internals. No door panels, no mirrors. $75pr
- Stock flat hood, few dents, driver quality. $25
- Driver quality 1 piece Chevy s10 grille, $25
- Frame mount rear hitch bumper. Not sure on brand. $25
- Stock front fenders. Rusty bottoms but could be saved since they are original GM fenders and not cheap reproduction junk. $25 Each
- Short Box, minimal surface rust, started to sand on decided to part the truck out. $300 with a tailgate of your choice.
*****1993 GMC Sonoma Cab WITH a clean title*****
Base model cab with manual pedal assembly and heat only firewall provisions. The rocker panels, cab corners, and floors are very rusty and will need replaced. It does have a good cowl panel, backwall, roof and windshield. This is a bare cab ready to cut apart and repair. The interior is gone, pedal assembly still there, HVAC is all gone, No column, no booster, no heater box, no rear window. $250 (Would sell the entire body of the truck in a package deal if someone was interested)
***** 1987 S10 2wd Reg. Cab Short Box T-5 Transmission*****
This transmission was mated behind a 2.8V6, this transmission only has 130,000 miles or so on it. I pulled it out of my personal pickup that I have owned for the last 9 Years.
The transmission will come with the shifter, a new clutch master cylinder, a new clutch slave cylinder, a brand new clutch kit from Carquest and the factory 2.8 Flywheel. I would recommend having the flywheel turned as it shows signs of heat spotting likely due to the last few times the truck was driven before the Original GM clutch let go. I still have the original clutch to show how worn out it was if someone wanted to see it. The complete transmission with all the new parts included I would like to get $750 obo.