Mechanical Part

Holley Street Demon carburetor.

Model 1901, 625cfm. Like new. $325 Mallory tachometer $35 SBC fuel pump @15

Mandan, ND

$325

2024-07-15 11:33:53

Ford transfer case borg Warner 1356 92-96 f-150

Manual shift Unknown miles but do know that it works

McClusky, ND

$150

2024-07-15 11:33:12

Chevy np203 transfer case

Was in 1982 but believe its a 73-79 case originally. Worked good when pulled

McClusky, ND

$200 OBO

2024-07-15 11:32:56

5 Photos

Ford c6 transmission and 208 transfer case

1983 c6 and 208 t case. They were bolted to a 351 small block. 160k miles on truck, previous owner claims both work. I never tested them myself but fluid

McClusky, ND

$350 OBO

2024-07-15 10:27:33

Wiseco Piston kit for Honda/Acura K566m815ap

Here is a set of new Wiesco Pistons with rings and pins. they are for 81.5mm Bore. 1990-2001, Honda/Acura B16a, B17,B18a/b motors also some other

Minot, ND

$600

2024-07-15 02:43:08

Freshly Rebuilt 263xhd Transfer Case

New parts. From bearings to seals to mode forks! Pump rub kit is also inplace! Clean. Open to offers. Cash/trades. Lmk thnx

Harrisburg, SD

Make an Offer

2024-07-14 22:43:11

Complete ford 9 inch Rearend from a 1957 ford car

Dickinson, ND

$500

2024-07-14 22:30:00

1968 Mercury Cougar original 390 2v intake, 2v carburetor, and Mercury 390-2v air

cleaner Asking $230 or best offer

Sidney, MT

$230

2024-07-14 22:26:30

Parted out a 2002 Outback for the motor, do not need these, will fit a 2000-2004 Outback, Legacy, or Baja. $20 takes the pair. Pick up in Glenburn

2000-2004 Subaru struts

Glenburn, ND

$20

2024-07-14 22:07:53

6.4 power stroke exhaust with muffler delete can deliver any place between Bismarc

k and garrison nd

Bismarck, ND

$350 OBO

2024-07-14 21:07:46

Hooker headers from. 77 blazer. No dents. Small block Chevy Should fit 73-87

pickup and blazer. Or suburban

Dickinson, ND

$100

2024-07-14 19:23:01

Looking for Chevy 350 engine for enduro car

Minot, ND

2024-07-14 15:38:42

These are the spot faced style The better ones. Set of 8.

351W Ford rods

Bismarck, ND

$25

2024-07-14 14:14:44

Ford flat head engine. Needs rebuilt but is all there. Make an offer.

Located in Glasgow Montana.

Glasgow, MT

Make an Offer

2024-07-14 13:19:13

Solo x-pipe for 09 pontiac G8

Installed for only a few miles and then removed, like new condition 2.5 inch piping with factory connections.

Bismarck, ND

$150 OBO

2024-07-14 12:25:49

Military jeep wheather proof distributor

Bowman, ND

$125 OBO

2024-07-14 11:53:45

1959 Oldsmobile Jetaway Hydramatic Transmission

Automatic transmission pulled from a 1959 Oldsmobile Dynamic 88 with the 371 Engine. Car was parked due to a head gasket, the motor was seized.

Bismarck, ND

$200

2024-07-14 11:51:10

Engine siezed up, the inside of this car is in great condition, it comes with a parts car. I have no idea the condition of the parts car besides the interior is destroyed and the exterior is in great

Pontiac g6 2005

Dickinson, ND

Make an Offer

2024-07-14 06:53:04

intake manifold for 292 ford engine 2barrel

Crosby, ND

2024-07-14 06:52:50

Crosby, ND

2024-07-14 06:29:19

1957 corvette intake manifold 3731398

Originally on a 283, fits Chevy small block

Mandan, ND

$100 OBO

2024-07-14 06:16:13

AC Delco Water pump for 6.2 diesel engine brand new still in box never opened

Onaka, SD

$60

2024-07-14 06:07:48

99/01 Mustang Cobra Gauge Cluster

99/01 Cobra Cluster. Has some scratch’s and one crack in the back. Unsure of mileage on the cluster. Buyer pays for shipping and PayPal fees. Thanks for your interest.

Dunn Center, ND

$120 OBO

2024-07-14 06:07:23

10 Photos

2003 Mach 1 4.6l 4V 60894 miles!

Comes with Ecu, Maf sensor, and all radiator hoses seen in pictures. The engine is from an 03 Mach 1 that was wrecked. I purchased the car with the intentions

Dunn Center, ND

$6,000 OBO

2024-07-14 06:06:50

10 Photos

2001 NOS 4.6l 4v Engine

2001 4.6L 4v Never had a drop of fuel run threw it! I have bore scope videos of each cylinder and will be posting a YouTube video of a detailed walk around and history of

Dunn Center, ND

$7,000 OBO

2024-07-13 19:26:59

Dodge Dana 60 hubs

Off of a late 70's early 80's passenger side drop, kingpin Dana 60. Big hub style. Seem to be in good shape, got em with a project truck. Don't need them.

Dickinson, ND

$40

2024-07-13 18:43:44

1989 Toyota auto trans o 3.0 moter $150

1989 Toyota auto trans on 3.0 moter $150, no emails ,cash only, 663-7293

Huff, ND

$150

2024-07-13 18:42:59

3.0 Toyota core moter $150

no emails ,cash only, 663-7293

Huff, ND

$150

2024-07-13 17:39:47

7 Photos

03/04 Ford Mustang Cobra Short Block

03/04 Ford Mustang Cobra Block with parts to assemble a built short block. Machined .020 over by L&M Engines with balanced rotating assembly. Comes with Eagle Crank, Eagle Rods, Diamond L&M pistons,

Dunn Center, ND

$4,500

2024-07-13 16:11:57